By Ian D. · 8 November 2026 · 4 min read
Changing a speed limiter without a depot visit
You can change a speed limiter remotely, over the air, across a whole fleet without booking a single vehicle into the depot. Set the limit per vehicle or group from your screen, push the change, and it travels over the telematics link. Nobody needs a ramp, a laptop or a driver sat waiting.
The old routine will be familiar. A limit needs changing, so the van has to come in. That takes a slot, a fitter and half a day off the road. Across thirty vehicles that is most of a week of lost work, spent on a number that took two seconds to decide.
Updating a limiter over the air
With TrackSpeed, the limiter our group makes and supports, the device talks to AutoM8 over the same telematics link as your tracking. Changing a limit becomes a software job rather than a workshop job.
You pick the vehicle or the group, set the new speed and send it. The vehicle picks the change up on its own. Nobody chases drivers to bring vans in, and nobody pays a fitter to plug into each one.
This earns its keep when the change is not your idea. A customer site drops its limit. A new contract caps motorway speed. A young driver joins and you want a lower ceiling on their van for the first few months. Each used to mean a depot booking.
Per vehicle or per group
Set a limit on a single vehicle, or set it once for a group and every vehicle in it follows. Group by depot, contract or vehicle type, whichever matches how you already think about the fleet.
Take forty 3.5 tonne vans and a handful of HGVs. Hold the vans at one limit and the trucks at another, change either set in a single push, and the wrong vehicles stay untouched. A new van added to a group inherits that group’s limit automatically.
Config templates per device keep this tidy. A template is your standard setup for a type of vehicle, so settings are not rebuilt by hand for each one. Build it once, apply it to the next van, and it matches the rest of that part of the fleet.
Rights matter too. A limiter is a safety and contract setting, so you decide who may change it. Everyone else can see the limit without being able to move it.
Zonal limits
A zonal limit is a lower speed that switches on when a vehicle enters a place you have marked, such as a depot, a yard or a customer site. It reverts to the normal limit as the vehicle leaves.
A fixed number set at the workshop cannot do this. Nobody has to remember the 5mph yard rule at the end of a long shift, because the vehicle handles it. Mark the zone, give it a limit, and every vehicle that enters complies.
All of this rides on the telematics link, so the active limit, and the speed against it, appear on the same journeys as your tracking. Open a trip on the live map and see what the limit was and how the vehicle drove against it.
Start with the limit you have been putting off
Think of the change you have avoided because it meant a depot visit: the young driver’s van, the site that asked for a lower cap, the group you set too high last year. That is the one to try first.
To see the remote push and zonal limits on a real vehicle, book a demo. The speed control feature page covers how it ties into driver behaviour scoring and vehicle tracking.
Related features