By Mike B. · 8 November 2026 · 4 min read
What a daily van walkaround check should cover
A daily van walkaround check should cover the tyres, lights, mirrors, windscreen, fluids and leaks, the load and the security of doors and bodywork. It takes five to ten minutes, and the driver does it before the van moves, every day it is used.
Picture it in a cold yard at 7am with a brew going lukewarm on the bonnet. The driver glances at a tyre, ticks the whole book in one go and drives off. Three weeks later a brake light turns out to have been dead the entire time, and a customer is the one who mentions it.
A check only works if it is quick and honest. The list below is built to be both.
The checklist
Walk the van clockwise and look at the same things in the same order every time. A fixed route stops you missing the same corner.
- Tyres: pressure looks right, no cuts or bulges in the sidewall, tread above the legal limit (1.6mm across the central three-quarters, per GOV.UK)
- Lights and indicators: headlights, brake lights, indicators, reverse, number plate light. Get someone to stand behind, or use a wall
- Mirrors and glass: mirrors secure and clean, windscreen free of cracks in the driver’s line of sight
- Washers and wipers: fluid topped up, blades not split
- Leaks: look under the van for fresh oil, coolant or fuel
- Fluids: a glance at oil and coolant levels
- Bodywork and doors: no loose panels or sharp edges, doors and load door shut properly
- Load: tools and stock secured so nothing flies forward under hard braking
- Horn and steering: horn works, no odd play in the wheel
- Number plate and fuel cap: plate readable, cap done up
Five to ten minutes covers the lot. Nothing sets a legal minimum time, but rushing is how that brake light stays out for three weeks.
Safety, and the paperwork behind it
There are two reasons the check matters. One is safety, and the other is the record that proves you took it seriously.
The safety side is obvious after a near miss. A bald tyre or a shifting load is an accident waiting for a wet roundabout, not a maintenance chore.
The record bites later. At a DVSA roadside check, or after an incident, the first questions are whether the vehicle was being checked and whether faults were logged and fixed. A clean run of daily checks is your evidence, and a blank book says the opposite. The DVSA side is covered in DVSA compliance for vans.
Paper book or phone
A phone check beats the paper book, mainly because of proof.
Paper tends to get filled in on Friday from memory. Every page says “nil” and nobody knows when anything was actually done.
On a phone, each item gets a tap, and when something is wrong the driver snaps a photo. The photo carries a timestamp and the vehicle it belongs to. A cracked light is then a dated picture against that van, visible to the office straight away, rather than a scribble.
That helps most when a defect needs a repair. The fault reaches the office without a phone call and the van gets booked in rather than running another fortnight on a bad tyre.
AutoM8 is building walkaround checks with photos alongside job management, so a reported defect can become a worksheet and the daily record sits under compliance. These parts are still being finished, so ask about them in a demo. For a delivery or courier operation with a lot of vans, a dated trail is what separates a calm audit from digging through glovebox books. More on that for delivery and courier fleets.
Try it once yourself
Print the list above, or set it up as a phone check, and ask drivers to walk the van the same way every day before it moves.
Then stand behind a van while a driver does it. Watch how long it really takes and what gets skipped. You will learn more in those ten minutes than from any policy document. The check is the cheapest safety habit a fleet has, and the only thing that wrecks it is doing it from memory on a Friday.
Related features
Compliance →Jobs & Worksheets →
For your field: Delivery & Courier →