By Ian D. · 8 November 2026 · 4 min read
What is dynamic speed limiting, and how does it work?
Dynamic speed limiting is a vehicle speed limiter you can change without touching the van. A limiter caps how fast a vehicle can go. The dynamic part means you set and adjust that cap from a screen, and it can drop automatically in certain places, where a conventional limiter holds one number until an engineer reprogrammes it.
What is a vehicle speed limiter?
A vehicle speed limiter is a device fitted to a vehicle that stops it exceeding a set top speed, however hard the driver presses the accelerator.
Compare it with the limiter on a child’s go-kart. The pedal works, the engine pulls, and past a certain point the speed simply holds. The driver keeps full control of steering and braking and just cannot go beyond the cap.
Older limiters were set once, at fitting. Changing the figure meant bringing the vehicle back to a depot so someone could plug in and reprogramme it. That works, but each change costs a visit.
What makes one dynamic
A limiter is dynamic when the cap can change after fitting, on your command or on its own.
Remote adjustment covers the first case. Say every van is set to 70 mph and you decide one group should run at 56 mph. You change the figure on screen, the vehicles pick up the new limit, and nobody drives anywhere.
Zonal speed covers the second. Draw an area on a map, such as a depot, yard or customer site, and give it a lower limit. A van doing 50 mph on the road is held to 5 mph as it rolls in through the gate, then returns to its normal cap on the way out. That matters wherever people walk among vehicles.
How it works in practice
The limiter holds the speed. The telematics link carries instructions in and status back out.
That link runs over the mobile network, so a new limit reaches the vehicle over the air, without a cable or a depot visit. The same connection reports position, which is what lets a zone trigger a lower cap when the van crosses its boundary.
If you already use an event engine to act on what a vehicle reports, a remotely managed cap is one more setting in the same place rather than a separate box to look after.
Where TrackSpeed fits
TrackSpeed is the speed limiter hardware that Scorpion Group makes, fits and supports, and it connects to AutoM8 over the telematics link.
You set the limit per vehicle or per group and send updates over the air. Config templates give devices of the same type the same setup, and permissions decide who may change a limit, so a cap is never something any user can quietly raise.
Because it shares the link with tracking, the active limit and the vehicle’s speed against it appear on the journeys you already review. Details are on the speed control feature page.
For the case for capping speed at all (safety, fuel, younger drivers), read speed limiters for fleets. To see how the cap sits alongside live positions, look at fleet vehicle tracking.
Related features