← All articles

By Alec J. · 8 November 2026 · 4 min read

What is route optimisation, and does it cut miles?

Route optimisation is software working out the best order to visit a list of jobs, and the best roads between them, so vehicles cover fewer miles and lose less time. It takes the day’s stops, rearranges them into a sensible sequence and picks the route, a task a dispatcher would otherwise do by hand each morning.

The suitcase comparison

Throw clothes into a case at random and the lid will not close. Fold and order them and everything fits with room to spare. Route optimisation does the folding for a day of jobs, with the same stops in a better order.

A driver with two jobs can plan the order mentally. With eight or ten spread across a county the number of possible orders is enormous and a person rarely finds the best. Software can check thousands of orderings in a second and settle on a good one.

What goes in and what comes out

Three inputs matter: where the jobs are, when each must happen and where each vehicle starts.

The software first geocodes each address, turning “14 Mill Lane” into a point on a map. It then measures real driving time between points using road data, because a river or a motorway junction changes the answer far more than straight-line distance does.

Next it sequences the stops, trying to keep drive time and distance low while obeying your rules, such as a boiler service that must happen before noon or a two-hour window promised to a customer. Each driver ends up with a running order, and the plan feeds the office’s scheduling so everyone sees who is going where. The general approach to that side is described on the job scheduling and dispatch page. AutoM8 is building it, so ask to see where it stands in a demo.

What it saves

It usually cuts miles, but treat the large percentages quoted online with suspicion. Published claims vary widely and depend on the fleet, so we have not put a figure on it here. Work out your own from a normal week.

Your starting point matters most. If an experienced dispatcher already plans tightly, software may trim only a little. If routes are thrown together each morning by whoever answers the phone, there is more waste to remove. Savings show up as less fuel, less wear and occasionally room for one more job in a day.

The shortest line on the map is not always best either. A slightly longer road with no queues and easy parking can beat a shorter one that crawls through a town centre, so good tools aim for least time and cost rather than least distance.

Where it falls short

A plan is made for the world as expected, and the world often disagrees. Traffic builds after the plan is set. Fixed appointment windows drag a vehicle across town at the wrong moment. Jobs overrun and push everything after them out of shape.

Software also cannot invent hours. Ten jobs and time for eight stays a problem however clever the routing, though a plan at least shows you that sooner.

Poor data wrecks the result. Wrong addresses, missing job durations and vehicles that are not truly available produce a tidy plan that falls apart by 10am.

Checking that it works

Compare miles per job and time per job for a normal week before and after, rather than judging by the look of the route map. Total miles, fuel spend and jobs completed per van per day show whether anything changed. The reporting and BI tools are built to surface figures like these.

If you want to test it on a few of your own vehicles first, read what a pilot should prove before you start.

Related features

Scheduling & Dispatch →Reporting & BI →

Next article

Buyer's guide: fleet management software for small UK fleets →

Book a demo →