← All articles

By Morgan P. · 8 November 2026 · 4 min read

What is a geofence, and how do fleets use one?

A geofence is a virtual boundary you draw on a map around a real place, such as a depot, a customer’s site or a restricted area. When a tracked vehicle crosses that line, the software notices and can alert you or log the time automatically.

Picture an invisible tripwire. Nothing marks it on the ground, but the moment a van’s GPS position moves across it, the system records an entry or an exit. Nobody has to be watching the map.

What is a geofence?

It is a shape the software treats as a boundary worth watching, usually a circle around a point or an outline you trace around a building, yard or postcode area. You draw it once and it sits quietly until a vehicle crosses it.

Plain tracking only says where a vehicle is. A geofence adds meaning to the location: arrived at the customer, left the depot, or turned up somewhere it should not be.

How the check happens

Each vehicle has a tracker that reports its position over the mobile network, many times a minute. Every time a position arrives, the software asks whether the vehicle is inside or outside each boundary. A change from outside to inside is an entry, and the reverse is an exit.

Those two events feed alerts, reports and automatic timestamps. For the wider picture of how trackers and position data fit together, what is fleet telematics covers the full chain.

Everyday uses

Arrival and departure alerts. Put a geofence round a customer’s address and get a notification when your engineer arrives or leaves. The office can update the customer without phoning the driver.

Time on site. Entry and exit times give the length of a visit with nobody writing anything down. That figure is useful for checking a customer’s hours or a contractor’s invoice.

Out-of-hours movement. Draw a fence around the yard and ask for an alert if a vehicle leaves it overnight or at the weekend. It is an early warning for unauthorised use or theft.

Regular places and no-go areas. Mark depots, frequent customers and anywhere vehicles should not be. Over a few months you can see which sites a vehicle visits and how often.

Geofence versus alert rule

The geofence is the boundary, and the alert is what you decide happens when it is crossed. One boundary can drive several rules. A single fence around the depot might send a manager an out-of-hours exit alert, log every entry as “back at base” and start a time-on-site count.

In AutoM8 those responses are set up in the device IO and event engine, and they appear on the same map as your live vehicle tracking, next to the vehicle that triggered them.

Limits worth knowing

A geofence says a vehicle crossed a line, not why. It also depends on a good GPS fix, so a very tight boundary in a built-up area can fire a false alert now and then. Draw the fence a little larger than the site rather than right up to the kerb and it behaves better.

If you want to see geofences drawn around your own sites, book a demo and bring the addresses.

Related features

Fleet Tracking →Device Event Engine →

Next article

Job scheduling: spreadsheets vs software, when to switch →

Book a demo →