← All articles

By Ben S. · 8 November 2026 · 4 min read

What is fleet telematics, and what does it do?

Fleet telematics lets a vehicle report on itself. A small box records where the vehicle is, how fast it is going and whether the engine is running, then sends that data over the mobile network to fleet management software you open on a computer or phone.

A fitness tracker is a fair comparison. The one on your wrist counts steps and heart rate, and the box in the vehicle logs location, speed and driving style. The numbers mean little alone. The software turns them into something a fleet manager can act on.

Two parts, one word

The term blends “telecommunications” and “informatics”, meaning information sent over a distance. In a fleet there are two halves, hardware on the vehicle and software in the office. You fit the box once and each vehicle then keeps the office updated without the driver writing anything down.

The box itself

It is usually wired into the vehicle and tucked out of sight. People call it a tracker, a telematics unit or just “the device”.

Inside sit a GPS receiver for position, a mobile SIM to send data and an accelerometer that measures braking and cornering forces. Some units also read the vehicle’s diagnostics, such as mileage or fault codes.

Scorpion has made vehicle electronics since 1973, and AutoM8 hardware is fitted and supported by the same group, so one company handles a device that needs attention.

What it sends

While the vehicle is in use the unit sends a steady stream of readings:

  • Location, refreshed every few seconds.
  • Speed, which can be matched against the road’s limit.
  • G-force, the strength of braking, acceleration and cornering.
  • Ignition, which marks when a journey starts and ends.

Each reading carries a time and a place, so the software can rebuild a whole journey afterwards instead of only showing a live dot.

What fleets do with it

Raw data does nothing by itself. Fleets use it for four main things.

Live tracking. Every vehicle appears on one map. You can send the nearest driver to a new job or give a customer an honest arrival time. This is the core of fleet and vehicle tracking.

Geofences. A boundary drawn round a site or depot tells you when a vehicle enters or leaves. What is a geofence goes into detail.

Driver behaviour. G-force and speed readings are scored to show who drives smoothly and who needs support. AutoM8 adjusts the score for the vehicle’s DVLA weight and drivetrain and judges speed against the UK enforcement threshold, so a laden van or an EV is not marked down unfairly. More in how fair driver scoring works.

Fuel and mileage. With every journey recorded, the software totals miles and highlights waste such as long idling or off-route trips.

Telematics and dashcams

Telematics records numbers about the vehicle, and a dashcam records video of the road and the cab. They suit each other. When the box registers a sudden stop, an AI dashcam can show the footage tied to the same journey on the same map. The numbers say something happened and the video says why.

Where to start

The reports built on this data are described under reporting and BI. To see readings from your own vehicles, book a demo.

Related features

Fleet Tracking →Reporting & BI →

Next article

Proof of attendance: photos, signatures and timestamps →

Book a demo →