By unit type
Cameras and MDVR
Installing a camera or MDVR unit - confirm the model, work the wiring checklist with photos, enable and name each channel, snapshot each one, then verify.
A camera or MDVR unit has its own install flow. On top of the shared steps it adds a model confirmation up front, a wiring checklist with photos, per-channel setup with snapshots, and its own verification. This page covers what is different from the standard hardwired tracker install.
Confirm the camera model
The flow opens with a Model step, Confirm camera model. It shows the make, model, number of channels and built-in cameras for the unit you unlocked. Check this matches the unit in your hand and the work order before you go on.
Choose the customer and vehicle
Choose the customer and vehicle as normal. See Choosing the customer and vehicle for the shared steps.
Work the install checklist
The Install step is a wiring checklist. Each required item on the checklist needs a photo before you can move on.
- Work down the checklist and complete each required item.
- Take the photo each item asks for. A required item is not done until it has its photo.
Then set up each channel. For every channel:
- Enable the channel.
- Name the channel.
- Scan and link its lens.
- Capture a device snapshot with Capture snapshot. Use Refresh preview to pull the latest image, and the optional live preview to check the view.
Snapshots poll for up to about 40 seconds. If a channel does not return an image you see Channel N did not return an image. Try again. - retry the capture from that channel.
You cannot complete the install until every required checklist item has its photo and every enabled channel has a snapshot.
Verify
The Verify step checks the unit is Online, has a GPS fix and has Location reported. Wait for all three before you complete.
Troubleshooting
Why can’t I complete the camera install? A required checklist item is missing its photo, or an enabled channel has no snapshot. Go back through the checklist and confirm every required item has a photo, then check each enabled channel has captured a snapshot.
Why did a channel snapshot time out? Snapshots poll for up to about 40 seconds. If one does not come back you see Channel N did not return an image. Try again. Retry the capture for that channel.
Related
- Unlocking a unit - how to unlock the unit with its IMEI and PIN.
- Choosing the customer and vehicle - pick the account and vehicle the camera unit will report under.
- Cameras and video - the office-side camera guide.