By unit type
Tachograph units
Installing a tachograph-capable unit - wire to the tachograph, configure the download line, and run a tacho test.
A tachograph-capable unit installs like a standard hardwired tracker, but adds three extra steps after the Power step: wiring to the tachograph, configuring the download line, and a tacho test. This page covers those three differences.
Tachograph-capable models include, for example, the FMC650 and the FMB640. Everything up to and including the Power step is the standard install.
Wire the tacho
After the Power step, the Wire step is Wire the tacho.
- Connect CAN2 to the tachograph’s C plug.
- Check the 120 ohm termination.
- Tick CAN2 wired and termination checked.
Configure tacho download
The Configure step is Configure tacho download.
- Choose the download line: CAN2, CAN1, K-Line or Off.
- Tap Push config to send it to the unit.
Tacho test
The Tacho test step confirms the unit is talking to the tachograph.
- Run the test.
- Confirm the tacho is responding and a driver card is seen.
- Tap Confirm tacho working.
Everything else - unlock, customer, vehicle, verify and complete - is the standard install.
The office manages tachograph downloads and driver hours once the unit is fitted. See the office-side guide below.
Related
- Unlocking a unit - IMEI and PIN entry for the unit.
- Choosing the customer and vehicle - the customer and vehicle search, same as for any other unit.
- Tachograph - the office-side tachograph guide.