The core install
Testing inputs and outputs
Confirm each wired input reads correctly and safely test outputs such as an immobiliser or beacon during commissioning.
After wiring, prove that each wire does what its role says. You trigger each input on the vehicle and watch the app see it change, then you operate each output and confirm it worked. The app only lets you confirm an input once it has actually seen it change, so you cannot mark something working that is not.
Safety first. Testing outputs operates real equipment on the vehicle. Make sure it is safe to switch a beacon, immobiliser or other output before you do. Never test an immobiliser on a vehicle that is not safely stopped.
Test the inputs
The Test inputs step shows a live HIGH / LOW pill for each wired input, which updates as the unit reports.
- Trigger each input on the vehicle - turn the key for ignition, press the panic button, open the door, and so on for whatever you wired.
- Watch its pill change between HIGH and LOW as you do. Until the app has seen it change it shows Waiting for signal….
- Once the pill has changed, tap Confirm working for that input. This button is only enabled after the app has actually seen the input change.
- If an input cannot be made to work, tap Not working - skip to mark it and move on.
Confirm working stays greyed out until the app has seen the input change. If it will not enable, the app has not seen a change yet - trigger that input on the vehicle again and watch the pill.
Test the outputs
The Test outputs step gives each wired output three controls - Force ON, Force OFF and Pulse 3s - so you can drive it and check it operates.
- Use Force ON, Force OFF or Pulse 3s to operate the output.
- Watch the equipment on the vehicle respond.
- When it operates, tap It operated - confirm working.
Immobiliser safety. An immobilise test is only accepted when the vehicle is confirmed stationary. If the vehicle is moving, or its speed or position is unknown, or the last stationary reading is more than 60 seconds old, the command is refused for safety and you see Blocked for safety - the vehicle must be stationary. Never attempt to test an immobiliser on a vehicle that is not safely stopped.
Troubleshooting
Why won’t Confirm working enable? The app has not seen that input change yet, so the button stays disabled and the input shows Waiting for signal…. Trigger the input on the vehicle - turn the key, press the button, open the door - and confirm once the pill changes.
Why was my output or immobiliser test blocked? This is the safety interlock. The vehicle must be stationary and reporting for an output test - and for an immobiliser especially. If the vehicle is moving, or its speed or position is unknown, or the last stationary reading is over 60 seconds old, the command is refused and you see Blocked for safety - the vehicle must be stationary. Get the vehicle safely stopped and reporting, then try again.
Related
- Wiring and powering up - set the role for each input and output before you test them.
- Verifying and completing - power up, check the unit and complete the install.
- Inputs and outputs (IO) - the customer-side explanation of what IO does once it is fitted.