Troubleshooting
Troubleshooting an install
Common problems during an AutoM8 install and how to fix them - PIN rejected, not reporting, no GPS, low voltage, ignition, already-claimed units and expired sessions.
Most installs go through cleanly, but a few things can trip you up in the field - a mistyped PIN, a unit that has not come online yet, a wire on the wrong circuit. This page lists the problems that come up most often and how to put each one right, so you can clear it and finish the job.
Troubleshooting
Why is the PIN or unlock being rejected? The IMEI or PIN is wrong, so you see Device not found or PIN incorrect. Re-check the work-order card, or scan the unit instead of typing. The PIN is at least 8 characters and is entered in capitals.
Why do I get “Too many attempts”? Unlock is rate-limited to stop repeated wrong attempts. Wait a minute and try again.
Why is the unit not reporting after I fit it? It has not come online yet - the verify and power step waits for a position. Check permanent power and ground and that the SIM and signal are active, then give it a moment.
Why is there no GPS fix? The GPS antenna needs a clear view of the sky, through plastic trim and not metal. Reposition it.
Why is the voltage low? The permanent live is not a true always-on 12V or 24V feed - it should read over 11V. Move it to a proper permanent live.
Why is ignition not detected? The white ignition wire is on the wrong circuit. It must be on a feed that changes when the key turns, so the ignition status flips key ON and key OFF.
Why can’t I test the immobiliser? The safety interlock refuses it unless the vehicle is confirmed stationary and reporting. Stop the vehicle and try again.
Why is the customer locked or the unit already registered? The unit is registered to a customer. Only an administrator can move a registered unit between customers.
Why did my session expire mid-install? The unlock session, which lasts about 2 hours, lapsed or you went offline. Re-unlock the unit with its IMEI and PIN to carry on. See Installing offline and resuming.
Why can’t I complete a camera install? A required photo or a channel snapshot is missing - capture the missing ones. A snapshot that times out with did not return an image can be retried.
Related
- Unlocking a unit - authorise a unit with its IMEI and PIN.
- Choosing the customer and vehicle - tie the unit to the right account.
- Wiring and powering up - set the role for each wire and power up.
- Testing inputs and outputs - the live input and output tests.
- Installing offline and resuming - save progress with no signal and resume later.
- Installer guide home - all installer topics.