← Installer guide

The core install

Verifying and completing

Power up the unit, check voltage, GPS, online status and ignition, then complete the install so the unit goes active.

The last step proves the unit is alive and reporting before you sign the job off. You power it up, check four readings, then complete the install so the unit goes active and the job is recorded. Do not complete an install until the unit is actually online.

Power up and check the four readings

The Power up step shows four checks in a grid:

  1. Voltage - the supply the unit is seeing. This is good at 10.5V or above.
  2. GPS fix - Yes or No, whether the unit has a satellite fix.
  3. Online - Yes or No, whether the unit has reported in.
  4. Ignition - ON or OFF, whether the unit sees the ignition.

Tap Start testing to begin. While the unit has not reported yet you see Waiting for the device to report in. Check power and give it a moment.

Finish install stays disabled until the unit is Online - that is, it has reported a position in the last couple of minutes. If it will not come online, check the power and the SIM and give it a moment.

Apply automation rules (optional)

An optional Rules step lets you set up the customer’s automation templates on the unit.

  1. Tap Apply to apply the customer’s automation templates, or
  2. Tap Skip to leave them for now.

Complete the install

When the unit is Online, complete the install.

  1. Tap Finish install.
  2. This sets the unit to Active and records the commissioning.
  3. The Installation complete screen appears with a summary - Device, Vehicle, Customer and Status = Active.
  4. Tap Finish to return to the dashboard, ready for the next job.

Completing the install does not create the licence. The unit only goes fully live once the office has an active licence on the account. Licensing is the office user’s job, not yours - confirm with them that a licence is in place if the vehicle needs to report straight away.

Troubleshooting

Why is Finish install greyed out? The unit is not Online yet - it has not reported a position in the last couple of minutes. Check the power and the SIM, give it a moment, and the button enables once the unit reports in.

Why is there no GPS fix? The antenna needs a clear view of the sky. Check it is mounted face up under plastic trim and not blocked by metal, then give it time to get a fix.

Why is the voltage low? The unit is not on a true permanent live. Move the permanent power feed to a proper permanent live so the reading sits at 10.5V or above.

Why is ignition not changing? The white ignition wire is on the wrong circuit. Move it to a circuit that changes with the key so the Ignition reading flips ON and OFF as you turn the key.