The core install
Wiring and powering up
Wire an AutoM8 tracker to the vehicle, tell the app what each input and output is connected to, and power up to confirm it is reporting.
Once the unit is unlocked and assigned, wire it into the vehicle, then tell the app what each wire is connected to. Getting the roles right here is what makes the vehicle’s events mean the right thing later, so take your time on this step.
Safety first. Follow the vehicle manufacturer’s guidance and your own safe-working procedures. Take care working around live circuits, and never leave a connection that could chafe or short.
Wire the unit and tick the connections
The Wiring step opens with a Connections checklist. These are the connections every install needs before the unit can report. Make each one, then tick it off.
- Connect Permanent power (12V/24V) to a true permanent live, then tick it.
- Connect Ground to a sound earth point, then tick it.
- Fit the GPS antenna + SIM - route the antenna, seat it and check the SIM is in - then tick it.
The permanent live should read over 11V. If it does not, you are not on a true permanent live - find a better feed before you go on.
The white ignition wire must go to a circuit that changes with the key, so the unit sees ignition flip as you turn the key ON and OFF. A permanent live here will make the unit think the vehicle is always running.
The GPS antenna needs a clear view of the sky. Mount it face up under plastic trim - it will not see through metal.
Assign a role to each input and output
Below the checklist you tell the app what each wired input (din1, din2, and so on) and output (dout1, dout2, and so on) is connected to. Set only the wires you have actually fitted.
- Set the role for each wired input. The first input, din1, is fixed to Ignition (locked) and cannot be changed, because ignition is always on the first input.
- For the other inputs, pick the role that matches what you wired: Ignition, Panic button, Blue lights, Siren, PTO / Equipment, Door, Tail lift, Bin lift, Refrigeration, Auxiliary or Custom.
- Set the role for each wired output: Immobiliser, Beacon, Auxiliary or Custom.
- Tap Save & continue.
Label a wire for what it is actually connected to on this vehicle. The role you pick here is what the app uses to decide what each signal means, so a wrong label gives the office wrong events later.
Power up
With the wiring saved, the Power up step verifies the unit - it checks supply voltage, GPS fix, online status and ignition before you complete the install. Work through that step next.
Troubleshooting
Why is din1 locked to Ignition? Ignition is always wired to the first input, so din1 is fixed to Ignition (locked) and cannot be reassigned. Put the ignition feed on din1 and use the other inputs for everything else.
Why should I not just tick the connections without checking them? Treat the checklist as a prompt to confirm real connections. If the permanent live, ground or antenna is not actually right, the unit will not report properly at the Power up step, and you will have to come back to it.
Why does the vehicle look like it is always running? The white ignition wire is on a permanent circuit instead of one that changes with the key. Move it to a circuit that switches with the ignition so the unit sees the key go ON and OFF.
Related
- Testing inputs and outputs - confirm each wired input reads correctly and safely test outputs.
- Verifying and completing - power up, check the unit and complete the install.
- Inputs and outputs (IO) - the customer-side explanation of what IO does once it is fitted.